Skip to content

Statewide

I have a private well. What should I check?

Idaho’s health department advises testing for bacteria and nitrate every year and for other contaminants every 3 to 5 years.

Research snapshot ·

Ready to paste into a message or email.

Copy this address: https://idahowaterstatus.com/explore/private-wells

Open the one-page brief

TL;DR

The short answer

  • Only a lab test of your own well shows what is in your water. Maps and nearby results help you choose which tests to order.
  • Nitrate can be especially dangerous for babies and pregnant people. If a baby or a pregnant person drinks the water, test for nitrate more often.
  • The state’s free test kit was marked sold out on November 6, 2026. Certified labs on the state’s list can still test your water.

What this means for you

Order a lab test for your well and keep the dated report. Use the state map and local studies to decide which extra tests to add. If a baby or a pregnant person drinks the water, test for nitrate more often. If you have a formula-fed baby under 6 months, test for manganese too. If nitrate, arsenic or uranium is high, do not boil the water, because boiling concentrates them. Call the state’s Environmental Health Program at 1-800-445-8647 for help with any high result.

A useful next step

Find Idaho’s lab list and sampling steps

Terms used in this guide
Test panel
The set list of substances a lab checks in one test order. No single panel covers everything.
Reporting limit
The lowest amount a lab reports as a number with its test method. Smaller amounts show up as not detected or as less than the limit.
Drinking-water standard
A limit public water systems must meet, set to protect health. Private well owners can compare their results to it.
Nitrate priority area
An area where at least 1 in 4 sampled wells had nitrate at half the drinking-water standard or more. The state ranks these areas to focus groundwater protection.

About 30% of Idaho residents use a private well as their main source of drinking water, says the Idaho Department of Health and Welfare (DHW). Unlike public water systems, private wells are not tested on a regular schedule. If you own one, keeping the water safe is up to you. State maps and studies can point to problems in your area, and a dated lab report tells you about your own well.

What should I test for, and how often?

DHW’s schedule, in the table below, starts with a yearly test for bacteria and nitrate. It adds tests for homes with a formula-fed baby, for farm areas and for water that tastes, smells or looks strange. DHW warns that nitrate can be especially dangerous for infants and pregnant people. The Idaho Department of Environmental Quality (DEQ) advises testing nitrate more often if a pregnant woman or an infant will use the water.

A lab’s standard panel checks a set list of substances, not everything. Ask the lab what a panel includes before you order. If you have a filter or water softener, ask the lab where to take the sample. DHW’s private-well page has step-by-step sampling instructions and videos.

Once a year

What to test for
Bacteria, nitrate

Every 3 to 5 years

What to test for
Arsenic, fluoride, selenium, uranium

Water tastes, smells or looks strange

What to test for
Chloride, manganese, sulfate

You live in a farm area or have underground petroleum tanks

What to test for
Pesticides, petroleum

You have a formula-fed baby under 6 months

What to test for
Manganese

Sources: [1] [6]

Can I get the free state test kit?

DHW offers free private-well testing through its Idaho Health Tools ordering site. On November 6, 2026, the kit page was marked sold out. DHW names 13 substances for the free test: nitrate, fluoride, arsenic, lead, uranium, manganese, chromium, nickel, copper, zinc, selenium, cadmium and barium. Bacteria are not on the list. Neither are per- and polyfluoroalkyl substances (PFAS), man-made chemicals that mostly do not break down.

The kit page allows one kit per household every five years. You must agree to have your results shown on DHW’s public groundwater map to get the free test. DHW says names and addresses are not shown. It also says processing can take up to two months and the offer runs while funding lasts. To test sooner, use a certified lab from DHW’s list and ask which tests it runs.

Sources: [1]

What can the state well map tell me?

DHW’s private-well map shows wells sampled since 2004 by three state agencies and by well owners. Each well shows its latest results for up to nine chemicals, with the sample year, the agency and the well depth if known. Search an address and the map shows wells within two miles. A well is colored red when a result was above a primary drinking-water standard.

Use the map to choose tests, not to judge your own well. Two nearby wells may show results from different years and different tests, and newer results may exist. The map’s ZIP code views count results above the nitrate or arsenic standard. A high count can reflect more testing as well as a real local problem. The map also leaves out bacteria, so test for bacteria every year whatever it shows.

Sources: [1] [2]

What have state groundwater studies found?

DEQ draws nitrate priority areas where at least a quarter of sampled wells had nitrate at or above 5 milligrams per liter (mg/L). That is half the 10 mg/L drinking-water standard. The 2020 list used records from 1990 through 2016, taking each site’s most recent result. DEQ calls the boundaries estimates of where nitrate is more likely to be high. Inside or outside a boundary, test your own well.

DEQ sampled wells in several of these areas in 2024. One was the Clearwater Plateau, around Cottonwood, Ferdinand, Craigmont and Nez Perce. There, 16 of 48 wells and springs (33%) had nitrate above the 10 mg/L standard. Eight sites tested positive for coliform bacteria, and one of those also had E. coli. Of 15 sites sampled before, four had higher nitrate, seven lower and four unchanged.

Another was the Weiser area in Washington County. There, DEQ resampled 60 home and irrigation wells, all of which it had also sampled in 2019. Thirty-two (53%) had nitrate above the standard, and 42 (70%) were above the arsenic standard. Five were above the uranium standard. Twelve tested positive for coliform bacteria, but no sample had E. coli. DEQ ran nitrogen isotope tests on the 43 wells with nitrate of 5 mg/L or more. The results were consistent with commercial fertilizer at 19 wells, a mix of organic sources at 18 and waste at 6. In its 2020 ranking, DEQ rated Weiser’s nitrate as having a downward tendency, one step short of what it calls a trend.

The Idaho Department of Water Resources (IDWR) sampled 204 wells statewide from June to September 2024. Twenty-nine (14%) had at least one result above a drinking-water standard. Arsenic was the most common, at 23 wells. One Clearwater Plateau well in its network rose from 0.24 mg/L of nitrate in 1994 to 17 mg/L in 2024. IDWR found PFAS in 7 of the 91 wells it tested for these chemicals, and six were home wells. Two of the seven, in Idaho County and Boundary County, had results above PFAS limits the U.S. Environmental Protection Agency set in April 2024. Each agency picked the wells it sampled, so these shares are not rates for all Idaho wells.

Sources: [3] [4] [5]

What should I do when my results come back?

Keep each lab report with the sample date, where the sample was taken, the substances tested, the results and the units. Check units before you compare: arsenic’s standard is 10 micrograms per liter, the same as 0.01 mg/L. A result marked “not detected” is different from a substance the lab never tested. If the lab’s method or reporting limit changes, the change may be in the test rather than the water.

If a result shows unsafe levels, call DHW’s Environmental Health Program at 1-800-445-8647 or email [email protected]. You can also ask your local public health district. DHW’s team can help you understand the result and choose the best fix. That may mean disinfecting the well, repairing the system, using another water source or installing a certified treatment device. Do not boil water with high nitrate, arsenic or uranium. DEQ warns that boiling concentrates them.

Sources: [1] [4] [6]

Follow the sources

Read our source summaries, or open the original documents to check the details.

  1. Idaho Department of Health and Welfare: private-well testing and free kit

    Web page: testing schedule, certified labs, free testing, the well map and help line. Its linked kit page was marked sold out on November 6, 2026.

    Original document: Idaho Department of Health and Welfare: private-well testing and free kit (opens in a new tab)
  2. Idaho Department of Health and Welfare: private-well water map

    Map description and the nitrate and arsenic ZIP code views

    Original document: Idaho Department of Health and Welfare: private-well water map (opens in a new tab)
  3. Idaho DEQ: how nitrate priority areas are chosen (2020)

    PDF pages 7–13: the 5 mg/L test, 1990–2016 records, boundaries and ranking; page 79: Weiser scoring sheet

    Original document: Idaho DEQ: how nitrate priority areas are chosen (2020) (opens in a new tab)
  4. Idaho DEQ: 2024 groundwater monitoring reports

    PDF page 2: list of areas; pages 3–7: Clearwater Plateau results; pages 34–37: Weiser results

    Original document: Idaho DEQ: 2024 groundwater monitoring reports (opens in a new tab)
  5. IDWR: 2024 statewide groundwater sampling

    Slides 5, 8, 10, 13 and 20–24: wells sampled, tests run, results over standards and PFAS

    Original document: IDWR: 2024 statewide groundwater sampling (opens in a new tab)
  6. Idaho DEQ: private wells and public water systems

    Web page: private-well testing, handling a concern and the warning not to boil

    Original document: Idaho DEQ: private wells and public water systems (opens in a new tab)
Cite or share this guide

Idaho Water. “I have a private well. What should I check?.” Research snapshot: 2026-11-06. Cite the original source for a specific figure.

https://idahowaterstatus.com/explore/private-wells